Template version:1
10/17
When any result is displaying, keeping on pressing button
“MEM” for three seconds,
current result will be deleted after three
“beep”.
Press the button “START/STOP”, the monitor will turn off.
11. ASSESSING HIGH BLOOD PRESSURE FOR ADULTS
The following guidelines for assessing high blood pressure (without regard to age or gender)
have been established by the World Health Organization (WHO). Please note that other
factors (e.g. diabetes, obesity, smoking, etc.) need to be taken into consideration. Consult with
your physician for accurate assessment, and never change your treatment by yourself.
Note: It is not intended to provide a basis of any type of rush toward emergency
conditions/diagnosis based on the color scheme and that the color scheme is meant only to
discriminate between the different levels of blood pressure.
12. TECHNICAL ALARM DESCRIPTION
The monitor will show 'HI' or 'Lo' as technical alarm on LCD with no delay if the determined
blood pressure (systolic or diastolic) is outside the rated range specified in part
SPECIFICACIONS. In this case, you should consult a physician or check if your operation
violated the instructions.
The technical alarm condition (outside the rated range) is preset in the factory and cannot be
adjusted or inactivated. This alarm condition is assigned as low priority according to IEC
60601-1-8.
The technical alarm is non-latching and need no reset. The signal displayed on LCD will
disappear automatically after about 8 seconds.
13.
TROUBLESHOOTING (1)
PROBLEM
POSSIBLE CAUSE
SOLUTION
LCD Display shows
abnormal result
The cuff position was not correct or
it was not properly tightened
Apply the cuff correctly and try
again
Body posture was not correct during
testing
Review the “BODY POSTURE
DURING
MEASUREMENT”
sections of the instructions and
