Operating Manual – V3.39
CENTOR EASY Force Gauge
- 11 -
CAUTION: if Auto-off displays NO, we advise you to use the force gauge with the charger to avoid
the measuring process being interrupted because of low battery condition.
3.
IN / OUT
The Centor EASY force gauge is equipped with a SubD15 pins
connector on the side. You can use this connector to connect it to an
external device in order to communicate. (See the appendix for pin
numbers). You can either:
•
Pedal: input to perform an action to the force gauge
•
Top1: output sending signal 0 or 1 when threshold is
reached
•
Anal: analogue output at 100Hz on 10bits
•
Digi: digimatic output, by example for printer
•
RS232: input/output sending current values continuously,
per request (pressing TDX button) or per computer action
Menu
Choices
Description
Pedal
TAR, MAX, TDX
Set the action of the pedal. It use a substitute to the action
of pressing a front panel button : ZERO (TAR), MAX or TDX
Top1
O, F, I+, I-, M+, M- Set the signal type sent through the TOR output :
positive impulsion (I+), negative impulsion (I-), Change
to positive state (M+) change to negative state (M-),
Open (O), Closed (F)
Anal
INT, NO
Active or de-active the analog output
Digi
NO, VLI, MXI, MNI Active the Digimatic output and set the value : current
value (VLI), maximum (MXI, minimum (MNI)
RS232
NO, IMP, CON
Set the RS232 output and its type : continuous or per
request imp (pressing TDX on the front panel button)
Menu
Choice
Description
LINE 1
VLI, MXI, MNI
Set the display of the first line 1 : current value (VLI),
Maximum (MXI), Minimum (MNI)
LINE 2
NO, VLI, MXI, MNI Set the display of the second line 2 : None (NO), current
value (VLI), Maximum (MXI), Minimum (MNI)
SIGN
NO, TRA, COM
Set if the sign is displayed and if yes the direction of the
positive sign : tensile (TRA) or compression (COM)
DECIMA
0,1, 2, 3, 4
Number of decimals
BARGRA
YES, NO
Display the bar graph or not
GONOGO
NO, PAS, FAI
Display or not the word PASS or FAIL when the limit is
reached
DIRECT
H, B
determines the direction of display, caution: the front
panel buttons are not affected by this parameter
AUTOFF
NO, 5, 10, 15
Determines if force gauge stops if no button is
activated after 5, 10, 15 min.
I N P U T S
P e d a l
O U T P U T S
T o p 1
A n a l
D i g i
R S 2 3 2
M E N U
T D X