1 6
Installation of the sun shield
Installation of the sun shield
The sun shield reduces sun-induced stresses in
the Load Stand
®
sensors and provides additional
protection for the sensors.
1.
With the junction box cover off, slightly loosen
the screws attaching the junction box to the
Load Stand.
2. Slightly loosen the horizontal screw(s) on the
bottom flange of the Load Stand.
3. Wrap the sun shield around the Load Stand,
slipping the cutout slots behind the loosened
screws.
4. Tighten the junction box screws and the horizon-
tal screw(s) on the bottom flange.
5. Replace the junction box cover.
Loosen Junction Box screws;
Re-thighten after sun shield
is installed
Slide sun shield behind junction
box and loosened screws.
Wrap sun shield around
Load Stand. Slide shield behind
Junction Box and loosened screws
on other end.
Screw not
on all models
Loosen bottom flange screw(s);
Re-thighten after sun shield
is installed.
Summary of Contents for Load Stand II
Page 23: ...23 Notes ...
Page 24: ...2 4 Notes ...
