MOUNTING INSTRUCTIONS
PAWL SPRING MOUNTING
Installing the winch is easy, if you follow these instructions. The numbers in ( ) refer to the
position numbers in the parts list.
Tools required for the installation:
• Allen key (4 mm)
• Allen key (5 mm)
• Ø6.5 mm (1/4”) drill
• Bedding compound
1. Drill bolt holes Ø6,5mm (1/4”) using the winch template.
Be sure that no dust comes in contact with the winch, while drilling.
2. Remove screw (1) and top cap (2).
3. Remove self-tailing arm (3) and drum (5).
4. Apply a light coat of bedding compound on the bottom of the base (16).
Ensure that each bolt hole is bedded. Keep drain grooves clear.
5. Fasten base (16) into place using 5 pcs. M6 (1/4”) countersunk head screws.
Use large washers or a backing plate.
6. Assemble in reverse order.
7. Check that the winch is functioning correctly:
- The drum should operate smoothly, when turning the drum clockwise by hand.
- The drum must not turn when trying to turn the drum anti clockwise by hand.
- While turning the winch handle clockwise the drum should turn slowly.
- While turning the winch handle anti clockwise the drum should turn quickly.
Note the curved
spring “arm”
• 5 x M6 (1/4”) countersunk head screws and corresponding
nuts (length depending on deck thickness)
• 5 x large washers or backing plate
• Ring spanner to match nuts
p4
40ST
(V.5.0)
40ST FS
(V.5.0.F)
