AND Device Net.Interface AD-4402 OP-21, Instruction Manual

Page: 6 / 28

Page 4 AD-4402 OP-21
3.
3. 3.
3. Panel and Names
Panel and Names Panel and Names
Panel and Names
3.1.1.
3.1.1. 3.1.1.
3.1.1. Node Address and
Node Address and Node Address and
Node Address and Data
Data Data
Data Rate
Rate Rate
Rate
Node Address
Set a node address for this slave device using binary switches (2
0
to 2
5
).
The node address range is 0 to 64.
Example: If address is 44, turn on the swithes of 32, 8, 4 (2
5
, 2
3
, 2
2
).
Data Rate (Baud Rate)
Set a data rate using switch DR0 and DR1.
Data rate 125 kbps 250 kbps 500 kbps Not used
DR0 OFF ON OFF ON
DR1 OFF OFF ON ON
Status LED
These LEDs indicate situation of the interface.
MS (Module Status) NS (Network Status)
Green ON Device operational On-line
Flashing Green Not connected
Red ON Unrecoverable fault Critical link fault
Flashing Red Recoverable fault Connection time-out
3.1.2. 3.1.2. 3.1.2. 3.1.2. Connector (Terminal) Connector (Terminal) Connector (Terminal) Connector (Terminal)
The connector style is the pluggable open connector. This connector consists of a
male connector and a female connector.
Female Connector
Pin Color
Symbol Description
1 Black V- Power-
2 Blue CAN_L Signal low
3 Bare Drain Shield
4 White CAN_H Signal high
5 Red V+ Power+
Male Connector
Connector of cable side
(Accessory)
NODE ADDRESS switches (1 to 32)
D ata R ate switch (0, 1)
MS Module Status LED
NS Network Status LED