A.
Turn off water supplies and drain lines.
B.
Clean installation site, remove any debris from
the area.
C.
Place faucet with Gasket(1) into singe hole deck.
D.
Assemble Rubber Washer(4), brass for metal
washer(5), and threaded Lock-Nut(6) on to
Shank(2) from underside of sink or mounting surfaces.
A.
Move handle into "OFF" position.
B.
Turn on water supplies. Check connections for leaks.
C.
Remove hand shower and let both hot and cold water
run for one minute. This will help clean any debris that
might otherwise clog the system. Replace hand shower.
D.
Operate handle up and down, in cold and hot positions,
to flush water lines thoroughly.
Three Hole Installation
Installation size map
Single Hole Installation
Test Faucet Installation
Simply rinse the surface with clear water or
mild liquid detergents if necessary Dry the
faucet with a clean soft cotton cloth Do not
use any cleaning agents containing
acids polish
a
brasives or harsh cleaners
Maintenance:
Spout body
Sink Deck
E. Hand-tighten Lock-Nut(6), use a screwdriver to
tighten Screws(7) on Lock-Nut(6).
F. Work your way around Lock Nut(6). Tightening the
screws sightly each time until all are snug to ensure
even pressure.
Step 1: Insert plate (1) and rubber
washer (2) before inserting spout
body into sink deck.
Step 2: Repeat steps D to F from
Single Hole Installation.
Step 3: Secure plate (1).
Step 4: Securing all connectors:
Ensure all connections are
tightly set in place to avoid
leakage.
