TETRA VIO
Chapter 6 : REMOTE CONTROL SOFTWARE
Your device is shipped with a Windows compatible
Remote Control Software
. This software allows you to control and make
all adjustments by a simple mouse click.
NOTE:
Preferably use Windows NT, 2000, XP or VISTA for LAN operation.
6-1. REMOTE CONTROL SOFTWARE INSTALLATION:
Turn your computer ON and wait for Windows to completely start.
Insert the CD-ROM into your drive: the ANALOG WAY home window will open automatically.
Select the language of the CD-ROM menus, then click on "Install a Remote Control Software" and select the name
of your device.
IMPORTANT:
If the Autorun is not enabled: From the Windows desktop, open My Computer and select the CD-
ROM drive. Select the Autorun folder, and then select the autorun.exe file.
Follow the Windows installation instructions.
NOTE:
The latest Remote Control Software (RCS) is also available our Web site
http://www.analogway.com
6-2. DEVICES CONNECTIONS
CONNECTING TO THE RS-232 PORT:
- Connect the serial port of your control device to the
RS-232
port (DB9 Female connector) of the device with a
straight
cable (DB9 Female / DB9 Male).
- Speed transmission:
9600 bauds, 8 data bits, 1 stop bit, no parity bit, and no flow control.
- Pin-out:
PIN #
FUNCTIONS
2
TRANSMIT DATA (Tx)
3
RECEIVE DATA (Rx)
5
GROUND (Gnd)
CONNECTING TO THE LAN PORT (optional):
- Connect the LAN port (RJ45 connector) of the device to your network according to your installation.
6-3. COMMUNICATION SETUP
Connect the RS-232 or RJ45 cable between the TETRA VIO and the control device as indicated in the section 6-2.
Then only power ON all of the devices.
Click on the program files TetraVio in
Start>program>ANALOGWAY>TetraVio
to run the software.
Click on
Controls
menu and select
RS232/LAN setup
, then:
•
CASE OF RS-232 PORT:
- With the front panel display menu of the device, verify that the RS-232 port is activating (
CONTROL >
RS232/LAN > RS232
).
- With the
Controls
menu of the software, select
RS232/LAN setup,
then in the
Connection Configuration
window select RS232 and the
COM
port number corresponding to the connection of the device.
If the communication is OK, the
message "
Device connected
".
DB9 female (Rear panel of the device)
PAGE 28
