HMC-T2000 User’s Manual HMC119983 Rev 1
4
which can be overridden by an external source. An AC wall type power supply is provided to
generate the required DC power for the unit. The detailed performance specifications are
listed in the datasheet on the Hittite website.
The user may control the frequency, power, and RF Standby functions from either the
Front
Panel
or the
USB interface
.
The RF Standby function will apply the maximum attenuation to
the RF output.
FRONT PANEL
I/O
USB I/O
CONTROLLER
SYNTHESIZER
CONTROLLER
SYNTHESIZER
700MHz –8GHz
PLL
10MHz
REF
10MHz
TCXO
POWER
REG
USB
REF
OUT
FRONT
PANEL
REF
IN
RF
OUT
+5VDC
+15VDC
-15VDC
Figure 1: HMC-T2000 Block Diagram
4
Installation of Equipment and Safety
The bulleted guidelines shown below must be followed for proper installation of the SG
equipment:
•
The SG equipment was designed for
LABORATORY USE ONLY
and is not protected
against moisture.
•
Utilize appropriate ESD handling procedures and precautionary measures
when installing this equipment.
•
The SG unit is intended for placement on a laboratory workbench.
•
During install make certain there are no obstructions that would impede air flow to the
venting of the unit on the top of the enclosure.
•
Ensure that all external components and RF/microwave coaxial cables are in proper
condition.
