Analog Devices EVAL-ADF7023DBxZ, Manual

Page: 27 / 49

R e v 1 . 1 | Page
27
Tx Setup in Packet Mode
The settings which follow are for use with EVAL-ADF7023DB1z daughter boards. If you are using a
different Daughter board, ensure that the frequency is set within the correct range of the board you are
using. Please refer to table x if you are unsure what the frequency range of you board is designed for.
Transmitter Board RF Settings
1. Ensure the S
econd
ADF7023 Daughter board is correctly plugged into the Second Mother board and that the
“ Current_State ” is “ PHY_ON ” on the Second instance of the ADF7023 Software.
Refer to
Connecting the Evaluation Boards section for setup procedures.
2. Select the “ RF Settings ” Tab (
Figure 34
point ( 1 ))
3. Ensure “ Packet mode ” is selected. (
Figure 34
point ( 2 ))
4.
Set the “ RF/Modulation” parameters as required. (
Figure 34
point ( 3 ))
(Note : Ensure the Transmitter RF/Modulation parameters are the same as the Receiver RF/Modulation
parameters previously setup).
5.
Set the “ Transmitter” parameters as required. (
Figure 34
point ( 4 ))
Figure 34