Analog Devices EVAL-ADF7023DBxZ, Manual

Page: 24 / 49

R e v 1 . 1 | Page
24
Receiver Board RF Settings
1. Ensure the First ADF7023 Daughter board is correctly plugged into the First Mother board and that the
“ Current_State ” is “ PHY_ON ” on the First instance of the ADF7023 Software.
Refer to Connecting the Evaluation Boards for setup procedures.
2. Select the “ RF Settings ” Tab ( Figure 31 point ( 1 ))
3. Ensure “ Packet mode ” is selected. ( Figure 31 point ( 2 ))
4. Set the “ RF/Modulation” parameters as required. (
Figure 31
point ( 3 ))
5. Set the “ Receiver” parameters as required. (
Figure 31
point ( 4 ))
If using AFC ensure the AFC pull in range is set to the desired value.
(A value of half the IF bandwidth is recommended.)
Figure 31