UG-1055
EVAL-ADAU1777Z User Guide
Rev. 0 | Page 16 of 25
HARDWARE DESCRIPTION
JUMPERS
Table 1. Connector and Jack Descriptions
Reference
Functional Name
Description
J1
Control port
Header that facilitates communication between the evaluation board and USBi board.
J2
5 V dc input
Barrel jack that provides external power to the board. It accepts 3.8 V dc to 6 V dc input.
J3
Power select
Jumper used to select power source for the evaluation board. Selectable between USB/external
and battery.
J4
Serial audio
Input and output header for serial audio signals in I
2
S, left justified, right justified, or TDM format.
J5
Battery 1.5 V
Jumper used to power the board via a 1.5 V battery.
J6, J7
Digital microphone inputs
Headers that allow digital microphones to be connected to the evaluation board.
J8
IOVDD 1777_IOVDD
Jumper connects power to the IOVDD supply of the
from the power supply section.
J9
MP pin jumpers
Jumpers used to connect push-buttons on the board to MP pins on the
J10
IOVDD_VDD
Jumper connects IOVDD on the
to VDD (3.3 V board supply) on the evaluation board.
J11, J14
Microphone bias
Jumpers used to add a microphone bias to the analog microphone inputs, AIN0 and AIN1.
J12
DVDD regulator (REG)
Jumper connects DVDD on the
to its internal regulator.
J13
Out R
Jumper provides access to the mono differential output right.
J15
Power down
Jumper used to power down the
analog and digital circuits.
J16
Out L
Jumper provides access to the mono differential output left.
J17
VDD AVDD
Jumper connects AVDD on the
to VDD (3.3 V board supply) on the evaluation board.
INTEGRATED CIRCUITS (ICs)
Table 2. IC Descriptions
Reference Functional Name
Description
U1
SigmaDSP
Digital audio signal processor
U2
M24C32-F serial EEPROM
Self-boot memory
U3
low dropout voltage regulator
Linear regulator that generates 1.5 V from an off-board power supply
U4
boost regulator
Boost regulator that generates 1.8 V or 3.3 V for the board supply from a 1.5 V input
LED
Table 3. LED Description
Reference
Functional Name
Description
D1
VDD power LED
LED that illuminates when the evaluation board is powered up