EVAL-AD7276SDZ User Guide
UG-450
Rev. 0 | Page 3 of 20
GETTING STARTED
QUICK START STEPS
To begin using the evaluation board, do the following:
1.
With the
EVAL-SDP-CB1Z
board disconnected from the
USB port of the PC, install the
AD7276
evaluation board
software from the CD included in the evaluation board kit.
The PC must be restarted after the software installation is
complete. (For complete software installation instructions,
see the Software Installation Procedures section.)
2.
Connect the
EVAL-SDP-CB1Z
board to the
EVAL-
AD7276SDZ
board as shown in Figure 2. Screw the two
boards together using the nylon screw-nut set included in
the evaluation board kit to ensure that the boards are
connected firmly together.
3.
Connect the 9 V power supply adapter included in the
evaluation board kit to Connector J1 on the
EVAL-
AD7276SDZ
board.
4.
Connect the
EVAL-SDP-CB1Z
board to the PC using the
supplied USB cable. If you are using Windows® XP, you may
need to search for the
EVAL-SDP-CB1Z
drivers. Choose to
automatically search for the drivers for the
EVAL-SDP-CB1Z
board if prompted by the operating system.
5.
Launch the
EVAL-AD7276SDZ
software from the Analog
Devices subfolder in the Programs menu.
Figure 2. Hardware Configuration—Setting up the
EVAL-AD7276SDZ
(
EVAL-AD7276SDZ
on Left and
EVAL-SDP-CB1Z
on Right)
9V PSU
EVAL-SDP-CB1Z
USB TO PC
10941-
002