UG-1124
EVAL-AD4111SDZ
User Guide
Rev. A | Page 4 of 26
EVAL-AD4111SDZ QUICK START GUIDE
RECOMMENDED QUICK START GUIDE
Use the following procedure to set up the evaluation board:
1.
Disconnect the
SDP-B
board from the USB port of the PC.
Install the
AD411x Eval+
software (available for download
from the EVAL-AD4111SDZ product page). Restart the PC
after installation.
2.
Connect the
SDP-B
board to the EVAL-AD4111SDZ
board, as shown in Figure 3.
3.
Fasten the two boards together with the enclosed plastic
screw washer set.
4.
Connect the
SDP-B
board to the PC via the USB cable. For
Windows® XP, the user may need to search for the SDP
drivers. Choose to automatically search for the drivers for the
SDP-B
board if prompted by the operating system.
5.
Launch the
AD411x Eval+
software from the
Analog
Devices
subfolder in the
Programs
menu.
QUICK START MEASUREMENT
Use following procedure to quickly capture data and test open
wire detection:
1.
Connect the dc signal source to the selected voltage input
(for example, VIN0 and VIN1 for differential input).
2.
Launch the
AD411x Eval+
software and select
Quickstart
mode.
3.
In the
Configuration
tab, under
Demo Mode
, click
All
Single-Ended
, and click
Sample
(see Figure 16).
4.
In the
Voltage Waveform
tab, the user can evaluate the
measured data and see the open wire error flag for
unconnected inputs.
The
Samples
numeric control in the top right corner of the main
window sets the number of samples collected in each batch.
17209-
002
15728-
002
Figure 3. Hardware Configuration
Downloaded from
Downloaded from
Downloaded from
Downloaded from
