UG-159
Evaluation Board User Guide
Rev. A | Page 12 of 24
EVALUATION AND TEST
To evaluate and test the performance of the ADF4106, use the
following procedure:
1.
Install the SDP-S software drivers. Connect the evaluation
board to a PC using the supplied USB cable. Follow the
hardware driver installation procedure that appears.
2.
Connect the SDP-S connector to the
EV-ADF4106SD1Z
.
3.
Connect a spectrum analyzer to Connector J2.
4.
Run the Int-N software.
5.
Select the SDP board and the
ADF4106
device in the
Select
Device and Connection
tab of the software front panel
window.
6.
In the software window, set the VCO center frequency
(Figure 19 uses a 5800 MHz VCO). Set the PFD frequency
to 1000 kHz, and program the reference frequency to equal
that supplied to Connector J11 (or the TCXO). See Figure 20
for the suggested setup.
7.
Measure the output spectrum. Figure 19 shows a 5800 MHz
output.
Figure 19. Spectrum Analyzer Display
Figure 20. Typical Evaluation Setup
09144-
019
Ref
-8.9 dBm
Att
20 dB
A
1 AP
CLRWR
Center
5.8 GHz
Span
2 MHz
200 kHz/
3DB
RBW 50 kHz
VBW 200 kHz
SWT 20 ms
-100
-90
-80
-70
-60
-50
-40
-30
-20
-10
low
Date: 29.NOV.2011 18:39:36
SPECTRUM
ANALYZER
PC
EXTERNAL DC
GND
EXTERNAL DC
SUPPLY
TCXO
VCO
LOOP
FILTER
LOCK DETECT LED
PLL
POWER
LED
EXTERNAL
POWER
SWITCH
SDP CONNECTOR
REFERENCE IN/
REFERENCE OUT
PLL
SDP-S BOARD
POWER
SUPPLIES
SIGNAL
GENERATOR
09144-
020
