UG-154
Evaluation Board User Guide
Rev. 0 | Page 6 of 16
09113-
011
Figure 11. ADXRS800 Evaluation Software Installation Welcome
From this point, complete the following steps to install the
evaluation software:
1.
Select the destination directory. The installer autopopulates
the names of the directories in which to store the software
GUI and required National Instruments products (see
Figure 12). You can change these directories; however,
most installations can proceed with the default values.
2.
When you finish selecting a directory, click
Next
. The
National Instruments Software License Agreement is
displayed.
3.
Read the license agreement before accepting it; then, click
Next
. The installer lists the required components to install
on your PC (see Figure 13).
4.
To start the installation, click
Next
. The installer completes
installation of the software evaluation GUI and all required
National Instruments drivers and run-time engines. After
the installation is complete, the box shown in Figure 14 is
displayed.
5.
Click
Finish
to complete the installation.
09113-
012
Figure 12. Destination Directory Selection
09113-
113
Figure 13. Start Installation (Listing Varies Based on PC Requirements)
09113-
014
Figure 14. Installation Complete
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
