Evaluation Board User Guide
ADXRS450 - UG
Rev. 0 | Page 7 of 17
HARDWARE CONFIGURATION
To configure the hardware, follow these steps:
1.
If not already connected, plug the USB A to Mini-B cable
into the PC.
2.
Connect the ISEB to the USB cable.
If prompted to install the device, see the Software
Configuration section for details on how to install and
select the correct driver.
3.
Ensure that the jumpers on the ADXRS450 satellite are in
their default configuration, as shown in Figure 9. This will
setup the board to use the on-board boost converter to
generate the device’s required high voltage supply. For
more information on using alternate high voltage supplies,
refer to the ADXRS450 datasheet as well as the Alternate
External High Voltage Supply section of this document.
Figure 15: Default Jumper Positions
4.
Connect the ISEB to the ADXRS450 satellite using the
18-inch, 20-pin ribbon cable. This cable is keyed to prevent
inserting it backwards and causing damage to the system.
5.
Connect theThe inertial sensor evaluation system should now be set up and
ready to use, and should resemble the setup shown in Figure 9.
Figure 16: Fully assembled evaluation Kit
Analog Devices
ADXRS800 Satellite
C
onne
c
tor
Default
Jumper
Positions
