Installation Tasks
1-16
ADSP-21262 EZ-KIT Lite Evaluation System Manual
3. Verify that the USB driver software is installed properly.
Open Windows
Device Manager
and verify that
ADSP-21262
EZ-KIT Lite
shows under
DSP Emulators
with no exclamation
point, as in
Figure 1-12
.
[
If using an EZ-KIT Lite on Windows 98, disconnect the USB
cable from the board before booting the PC. When Windows 98 is
booted and you are logged on, re-connect the USB cable to the
board. The operation should continue normally from this point.
Starting Vi+
To set up a session in Vi+:
1. Verify that the yellow USB monitor LED (
LED11
, located near the
USB connector) is lit. This signifies that the board is communicat-
ing properly with the host PC and is ready to run Vi+.
2. Press and hold down the keyboard
Control
(CTRL) key.
Figure 1-12. Device Manager Window
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from