Analog Devices ADP5063, User Manual

Page: 3 / 13

Evaluation Board User Guide UG-595
Rev. 0 | Page 3 of 12
EVALUATION BOARD SOFTWARE
INSTALLING ADP5063 EVALUATION SOFTWARE
Before installing the ADP5063 evaluation software, the drivers
for the USB-SDP-CABLEZ must be installed. The software
drivers are included on the ADP5063CP-EVALZ setup CD
and the instructions can be obtained from www.analog.com/usb-
sdp-cablez . After proper installation of USB-SDP-CABLEZ
drivers, insert the ADP5063CP-EVALZ setup CD and run the
Setup.exe file.
USING THE SOFTWARE GRAPHICAL USER
INTERFACE (GUI)
The following are the GUI operation controls and status tools
(see Figure 2):
1.
Operation parameter controls
2. Functional enables
3. Interrupt register indicator (Register 0x0A)
4. Charger status
5. Battery status
6. Fault indicators
7. Watchdog control
8. Digital I/O controls
9. I 2 C communication status indicators
OPERATING THE BOARD WITH THE GUI
Complete the following steps to use the board:
1.
Before running the software, ensure that the Analog Devices
USB-SDP-CABLEZ is plugged into the USB port of the PC.
2. Connect a 5 V power supply to VIN_F.
3. Click START > All Programs > ADP506x GUI 3Vx SDP >
ADP506x GUI SDP . Once this step is done, the software is
ready to use.
VIN must be above 2.5 V in order for the I
2
C communication of
the ADP5063 to start working. The VIN voltage level is monitored,
and the indicators are shown in the charger status indicators
(see Number 4 in Figure 2). The GUI automatically reads the
content of the registers after every 0.3 seconds from the last
action and updates the status of the registers on screen.
If there is a problem in the I
2 C communication, the status
indicators show an error message (see Number 9 in Figure 2).
When I
2 C communication is operational, status indicators
show I2C_STATUS_OK (see Figure 2).
Figure 2. ADP5063 GUI Operation Control and Status Tab
1
1737-
002
3
2
1
7
4 5
6
8
9