Analog Devices AD5758, User Manual

Page: 6 / 20

UG-1268 EVAL-AD5758 User Guide
Rev. 0 | Page 6 of 20
6. A new window appears as shown in Figure 5. Find the
Board.AD5758
plug-in and click the
Install Selected
button.
The EVAL-AD5758SDZ plug-in is now installed and is
displayed as shown in Figure 6.
1671
0-
205
Figure 5. Plug-In Manager Window
16
710
-20
6
Figure 6. Attached Hardware Section when the EVAL-AD5758SDZ is
Connected
7. Double-click EVAL-AD5758SDZ to open the AD5758
block diagram (see Figure 7). The INITIAL CONFIG-
URATION menu appears on the left. This location is
where several register settings can be configured and are
written to the device in the appropriate order. The DIG_
DIAG_STATUS, RESET_OCCURED, and CAL_MEM_
UNREFRESHEDLED indicators are highlighted red by
default. Writing the initial configuration values clears these
error flags. If the device is power cycled, or if the USB cable
is disconnected and reconnected while the
ACE software is
open, contact with the EVAL-AD5758SDZ may be lost. If
contact is lost, click the
System
tab. Then, click the USB
symbol on the EVAL-AD5758SDZ, and then click Acquire
to communicate with the EVAL-AD5758SDZ again.
16
710
-105
Figure 7. AD5758 Block Diagram in the ACE Software