EVAL-AD5758
User Guide
UG-1268
Rev. 0 | Page 5 of 20
SOFTWARE QUICK START PROCEDURES
INSTALLING THE
ANALYSIS|CONTROL|
EVALUATION (ACE)
SOFTWARE AND
AD5758
PLUG-INS
The EVAL-AD5758SDZ software uses the Analog Devices, Inc.,
ACE
software. For instructions on how to install and use the
ACE
software, go to
www.analog.com/ACE
.
After the installation finishes, the EVAL-AD5758SDZ
evaluation board plug-in appears when opening the
ACE
software (see Figure 2).
16
710
-00
2
Figure 2. EVAL-AD5758SDZ Evaluation Board Plugin Window after Opening
the
ACE
Software
INITIAL SETUP
To set up the EVAL-AD5758SDZ, take the following steps:
1.
Connect a USB cable to the PC and then to the
EVAL-SDP-
CS1Z (SDP-S)
.
2.
Connect the
EVAL-SDP-CS1Z (SDP-S)
to the EVAL-
AD5758SDZ. The PC recognizes the EVAL-AD5758SDZ.
3.
Power up the EVAL-AD5758SDZ with the relevant power
supplies.
4.
If not opened already, open the
ACE
software. The EVAL-
AD5758SDZ appears in the
Attached Hardware
section.
16
710
-003
Figure 3. EVAL-AD5758SDZ Plug-In Not Installed
5.
When setting up the evaluation board for the first time, the
EVAL-AD5758SDZ plug-in may need to be installed. If the
plug-in appears as shown in Figure 6, then go to Step 7. If
the plug-in appears as shown in Figure 3, then click on the
button circled in red in Figure 3. After clicking this button,
the pop-up window shown in Figure 4 appears. Click yes.
16
710-
0
04
Figure 4. Installing the Plug-In Pop-Up Window
