27
7. Click the “Test Outputs” box (to remove the tick
from it) and acknowledge the message about
saving neutral settings.
Remove the battery, Click the Save button and
then re-connect the battery
Click the “Test Outputs” box (to put the tick back
in it) and once again acknowledge the message
about saving neutral settings.
9. Remove the tick out of Test Outputs (all motors
will stop)
Acknowledge the message about saving your
Neutral settings and Click Save
10. Now return to Step 3. Above and repeat all
steps in the process up to this point (for any other
motors which are not working correctly)
Once all motors are working correctly. Disconnect
your battery, Ensure that you have removed the
Tick from “Test outputs” and Click Save
Exit the OpenPilot Software, Disconnect your USB
lead and continue.
8. Several motors will probably now start turning,
but you need to adjust the slider for the 1st motor
until it is turning at the lowest, smooth and
constant rate
