background image

Joystick 

Cable Wiring (cont’d

The instructions contained in this guide will specify how to handle, wire, and secure cables from the joystick to the 
backrest. 

WARNING: Regardless of where a cable is attached, it is very important not to let any cable stick out from the 
wheelchair or form a loop that could catch on external objects when moving around in the chair. This could cause 

severe damage in the wheelchair’s compone

nts or power supply. 

 

Note : 

The white or yellow tie-wraps shown in the images in the following pages are for illustrative purposes only, as 

these ties are normally black. 
Before making any adjustments, it is important to note where and how the cables are attached, so that they are 
placed in the same location and attached in the same way. 

 

TABLE OF CONTENTS

 

table of contents .............................................................................................................................................................. 2

 

1.

 

How to attach excess cable for a non-reclining backrest with electronics ........................................................ 3

 

Cables inside the electronic box ......................................................................................................................... 3

 

Cables inside the module cover .......................................................................................................................... 4

 

2.

 

How to attach excess cable for a power reclining backrest .............................................................................. 5

 

3.

 

Adjusting a fixed or swing away joystick .......................................................................................................... 6

 

Changing the angle of a joystick mount from the factory-standard of 0° to 35° ............................................... 6

 

Reversing the joystick mount angle from 35° back to 0° .................................................................................... 7

 

4.

 

Adjusting armrest height .................................................................................................................................. 8

 

Dual post armrest height adjustment ................................................................................................................. 8

 

Cantilever of reclining armrests height adjustment ............................................................................................ 8

 

 

 

 

 

 

Summary of Contents for ALLTRACK Series









Reviews: