Joystick
Cable Wiring (cont’d
)
3
Introduction :
The instructions contained in this guide will specify how to handle, wire, and secure cables from the joystick to the
backrest.
Tie-wraps:
•
B00051 = 5.5
”
(140 mm)
•
B00052 = 7.5
” (
190 mm)
•
B00053 = 11
”
(280 mm)
1.
How to attach excess cable for a non-reclining backrest with electronics
Cables inside the electronic box
a)
The following instructions apply to an ISM Module (Image A) or an e-bx (Image B).
b)
Using cutters, cut and remove B00051, B00052, and B00053 ties as shown in images A and B.
c)
Adjust length of cable according to changes done.
d)
Coil cables as tightly as possible on the backrest plate and attach together using B00051 and/or B00052 ties.
e)
Make sure cables are placed and attached at the same location as shown below.
