AMX PT10-PLV, Instruction Manual, Page: 15 / 32

Installation and Wiring
11
PT10-PLV Single Camera Pan/Tilt System
Using the camera control RS-232 DB-9 connector
The RS-232 DB-9 (male) connector on the AXB-PT10 connects to the camera head's RS-232
connector. The following table lists the pinouts and shows the pin configuration for the DB-9
connector.
Wiring Information for the AXP-PLV
The AXP-PLV comes with a mini-XLR cable.
Using the AXlink mini-XLR connector for data and power
Wire the Master Controller's AXlink connector to the mini-XLR connector (male) on the rear panel
of the AXP-PLV for data and 12 VDC power as shown in FIG. 12.
FIG. 11 AXlink connector and local +12 VDC power supply wiring diagram
Camera Control DB-9 RS-232 Connector Pinouts
Pin Signal Pin Signal
1 N/A 6 N/A
2 RXD 7 RTS
3 TXD 8 CTS
4 N/A 9 N/A
5 GND
FIG. 12 Mini-XLR connector wiring diagram
PWR+
AXP/TX
AXM/RX
GND-
PWR+
AXP/TX
AXM/RX
GND-
PWR+
GND-
Local +12VDC power supply
(coming from the PSN6.5)
2-pin power connector
Pin 1
Pin 9
1
2
3
4
4 - PWR+ (red)
3 - AXP (white)
2 - AXM (green)
1 - GND- (black)
PWR+ (red)
AXP (white)
AXM (green)
GND- (black)
To AXP-PLV
To Master Controller