AMX PT10-PLV, Instruction Manual, Page: 13 / 32

Installation and Wiring
9
PT10-PLV Single Camera Pan/Tilt System
Wiring Information for the AXB-PT10
Each PosiTrack Controller has an RS-232 DB-9 connector, lens control DB-15 high-density
connector, and an AXlink 4-pin connector. Always provide enough cable to accommodate the
desired range of motion for the PosiTrack unit and its camera/lens. The Lens Power switch on the
control panel (FIG. 10), removes any power noise on the incoming video by turning power On/Off
to Pin 1 of the DB-15 lens control connector when the camera/lens is powered from a separate
supply.
The AXB-PT10 receives all power through the +12 VDC and GND connections on the 4-pin
AXlink connector. The portion of the power directed toward the pan and tilt motors is fused. The
fuses are self-resetting.
FIG. 9 PT10 and pedestal mount
Cradle support bracket
Wire
tie-mount
Camera mount assembly
Pedestal mount
The camera/lens cradle can be mounted on either side of the cradle support bracket. This is
especially useful when the camera is mounted to the ceiling.
When applying power to the AXB-PT10, adjust the soft-set pan/tilt-limit stops to a safe position to
prevent camera or AXB-PT10 damage.
FIG. 10 Side view of the AXB-PT10 showing the location of the AXlink connector.
Camera control RS-232 DB-9
(male) connector
AXlink 4-pin (male) connector