Setup Mode
8
Mio Modero R-3 Remote
Download Mode
In order to download new firmware or a new configuration or font file to the Mio R-3 remote using the
remote's program port (see
Using the Programming Jack on The Mio R-3
section on page 11 for details),
the remote must first be placed into
Download
mode. Press
3
on the remote to toggle the
Download
mode
OFF
and
ON
. The
Download
mode must be ON before you can download a file to the Mio R-3
device. While the
Download
mode is
ON
, the device will not go to sleep. Once the download is
complete, this setting must be returned to
Download Off
. A firmware download will cause the remote to
reset and this will automatically reset the remote to
Download Off
.
To leave
Download
mode, press the
EXIT
button.
Debug Mode
Pressing button
4
on the remote toggles
Debug
mode between
ON
and
OFF
.
The remote has a useful feature known as
Debug
mode. When the remote is in
Debug
mode, pressing
any of the remote's buttons will cause the remote to display the corresponding channel code (used for
programming the control system) on the remote. The channel code will be shown on the remote as long
as the button is pressed. The remote indicates that it is in
Debug
mode by displaying the word
DEBUG
between button presses.
Pressing the
4
button toggles to the new mode. 30 seconds after selecting the mode, the menu returns to
Setup
mode.
Firmware Version
Pressing button
5
on the remote displays the remote and ZigBee firmware versions currently loaded on
the remote. To view the available firmware versions, press the
Move Up
arrow on the scroll wheel (refer
to the
The Mio Modero® R-3
section on page 1 for more information) to scroll up. and pressing the
Move Down
arrow will scroll down. When finished, press
Exit
to save the changed firmware
information and leave
Setup
mode.
Device ID
Pressing button
6
displays the device’s Device ID number. The default Device ID number is 10001, with
the first "1" highlighted, signaling to the user that it can be changed.
To change the Device ID number, press the
Move Up
arrow on the scroll wheel to scroll up. and pressing
the
Move Down
arrow will scroll down. To move the cursor to the next number, use the
Move Left
or
Move Right
arrows on the scroll wheel to change positions.
After all numbers have been configured as desired, pressing the center button on the scroll wheel will
store the entered Device ID into memory. After the Device ID is stored into memory, the display will
return to
Setup
mode.
LED Awake Brightness
The red LEDs that backlight the Power button when the remote is awake are also used to indicate
charging status. These LEDs will slowly blink on and off if the remote is place in the charging cradle and
the Lithium-Ion battery pack is being charged. The LEDs will remain on when charging is complete.
Pressing button
7
will change the brightness of the Power LED from
Low
, to
Med
and then
High
.
Pressing the button again toggles to the new mode. 30 seconds after selecting the mode, the menu returns
to
Setup
mode.