AMX DESIGN XPRESS HOME THEATER V1.3 - ON SITE INSTALLER GUIDE, Instruction Manual

Page: 8 / 30

On-Site Installer’s Guide - Overview
4
DXP-HT v1.3 - On-Site Installer’s Guide
The Button # refers to the button number or scene number the DXP-HT system is to
emulate when communicating to the lighting system.
For AMX Radia , the button # is the scene number to be recalled when this scene is
selected on the touch panel.
For Clipsal C-Bus and Dynalite systems (used primarily outside the U.S.), the button #
consists of the button number plus the fade rate, separated by a semi colon.
For example:
(C-Bus): K:P:[A4:E1]:75:8 indicates network $E1, group address $A4, go to 75%
at 8-second fade rate.
(Dynalite) : K:P:[14]:12:25 indicates area #14, go to preset scene #12 at 25-second
fade rate.
The Clear button clears the Preset Name , Address and Button Number information for a
selected preset.
Note for ALD-D48 Lighting Systems
The ALD-D48 is not controlled by Send Commands, so each button on the touch panel or keypad
corresponds to a specific dimmer.
For instructions on developing NetLinx code to program scenes for the D48, refer to Tech Note #
TN 543, available via www.amx.com (Dealers > Tech Center > Tech Notes).
Note for Radia Lighting Systems
On Radia lighting systems, channels 1-128 represent Radia lighting presets 1-128. If a channel is
on, then the corresponding preset is on. However, on startup NetLinx resets all channels to 0 (OFF).
Radia does not report the status of its channels when the master comes up, and consequently the
software believes the state of all of the presets is OFF. Therefore, until a preset changes in the
system, the channel states are not reported.
It is important to have the Lighting Preset information prior to finishing the project.
Enter a new Preset Name , Address and Button Number , and click the Add button to add a
new preset to the bottom of the list.
Select a Preset in the list and click the Delete button to delete that preset from the list.
The Insert button inserts a new preset at the order number of the currently selected
preset.
Click the Apply button after editing a preset to apply the changes.
The Clear button clears the Preset Name , Address and Button Number information for a
selected preset.
For detailed configuration information on the ALD-D48, refer to the ALD-D48 Network
Lighting Solution Instruction Manual, also available via www.amx.com (Dealers >
Tech Center > Tech Docs > Instruction Manuals).