![background image](http://html.mh-extra.com/html/amx/das-d-0404/das-d-0404_operation-and-reference-manual_2937825071.webp)
RS-232 Control Commands / Messages
63
Delta Series Audio Controllers
RS-232 Control Commands / Messages
Delta Audio Controllers provide an RS-232 (DB9) port for receiving RS-232 Controller Commands.
Refer to the
RS-232 Controller Command Messages
section on page 55 for a complete listing of
supported commands.
Connector: DB9 Male
Communications: 4800 Baud, 8 data bits, 1 stop bit, no parity
The Matrix Distributed Audio, multi-room audio control systems can be externally controlled by sending
ASCII text command strings to the Bi-Directional RS-232 serial interface. Every command must be
terminated with a line feed (0x0A). All messages are case-sensitive.
The MRC will respond to command messages with a status response message once the command has
been executed.
This section provides reference information for the following:
RS-232 Controller Command Messages
- These commands can be sent directly to the Delta
Audio Controller via the RS-232 (DB9) port on the rear panel. See the
Connecting the RS-232
Serial Port
section on page 19 for connection and DB9 cabling information.
Delta Audio Controller Status Messages
(page 67) - These messages are received via the
RS-232 port, and are used primarily for troubleshooting purposes.
Source Command Codes
(page 70) - Source Command Codes, received from the SWT
keypads are referenced here by Source Type and Command Index.
RS-232 Controller Command Messages
RS-232 Controller Command Messages
MVER
Get Firmware Version
Firmware Status Version
- or -
ERR
MGCF
Get Configuration
Configuration Status
- or -
ERR
FNIC
Get Number of IIC devices
Num IIC Devices Status
- or -
ERR
FGICx
Get IIC Device Status, where:
‘
x
’ is the IIC device index, valid values range from 1 to the
number of available IIC devices as reported in the ‘Num IIC
Devices Status’
IIC Device Status
- or -
ERR
MSVLr,v
Set Volume, where:
• ‘
r
’ is the desired room, (1-64)
• ‘
v
’ is the desired volume level, valid values are:
101: Mute
0....70: 0....-70 dB
Volume Status
- or -
ERR
MGVLr
Get Volume, where:
‘
r
’ is the desired room, (1-64)
Volume Status
- or -
ERR
Summary of Contents for DAS-D-0404
