![background image](http://html.mh-extra.com/html/amx/das-d-0404/das-d-0404_operation-and-reference-manual_2937825019.webp)
Wiring and Connections
11
Delta Series Audio Controllers
The Delta Controller learns the IR commands for power on/off during the programming setup. Source
components are turned on when they are selected on the keypad. The source remains on until it has been
idle in all zones for a duration of 10 minutes, then Delta will automatically turn it off until it is selected
again.
AM/FM Tuner Connections
The internal AM/FM tuner does not require any special programming or setup other than presets.
1.
Connect a 75 Ohm adaptor and antenna to the FM coaxial plug.
2.
Connect the two leads of an AM loop antenna to the AM spring clips.
3.
Position both antennas as high as possible to allow for optimal station reception.
FIG. 5
Source Unit to Controller Connections
Source Input #1 is left open because the default is the internal AM/FM tuner.
Make sure that the IR emitter output is plugged into the same numbered IR port as
the source component input RCA jacks.
Summary of Contents for DAS-D-0404
