Programming
7
AXB-DTMF+ DTMF+ Interface
Programming
Program the AXB-DTMF+ to send outbound DTMF codes using Axcess Send_Commands from
the control
Fine Tuning - commands allowing experienced users the ability to obtain performance in adverse
system. Use the commands described in this section with the Axcess Programming Guide to
program the AXB-DTMF+. The Send_Commands are divided into the following categories:
!
Operative
: normal day-to-day commands controlling the overall operation of the AXB-
DTMF+.
!
Timing
: control the AXB-DTMF+ signal timing (not necessary in most
situations).conditions.
!
Distinctive Ring
: commands that define distinctive ring patterns.
Send_Commands
Send_Commands are stored in the central controller and direct the AXB-DTMF+ to perform
various operations.
Operative Send_Commands
The following table lists Operative Send_Commands that produce control of the AXB-DTMF+.
The commands are listed alphabetically by operation and include syntax, syntax descriptions, usage
examples, time increments, and reset default values.
Operative System Send_Commands
Command
Description
AGAIN-OFF
Control gain of the audio (voice) signal from the phone lines to the audio output
of the AXB-DTMF+. Setting the gain to off causes it to return to the default
level.
Default at reset = YES
Example:
SEND_COMMAND DTMF, 'AGAIN-OFF'
Sets the audio gain to low from the AXB-DTMF+ to default (no amplification
boost).
AGAIN-ON
Control gain of the audio (voice) signal from the phone lines to the audio output
of the AXB-DTMF+. Setting the gain to on increases the gain above the default
level.
Default at reset = NO
Example:
SEND_COMMAND DTMF, 'AGAIN-ON'
Sets the audio gain from the AXB-DTMF+ to high (amplification boost).
AUDIO-OFF
Disable audio from passing through the AXB-DTMF+ to the phone line.
Default at reset = YES
Example:
SEND_COMMAND DTMF, 'AUDIO-OFF'
Disables the audio from passing through the AXB-DTMF+ to the phone line.
