For full warranty information, refer to www.amx.com.
7/07
©2007 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-40-825
REV: A1
Installation
Modules
Important: Always use a UL approved power source. Check the power source’s
documentation for information specific to that power source.
To attach connectors & power to a module:
1.
Insert the RJ-45 connector into the RJ-45 (CAT-5) receptacle (FIG. 4).
2.
Insert the HD-15 connector (see pinout in FIG. 6) into the HD-15 (RGBHV)
receptacle (FIG. 4).
3.
Plug the power cord into the power jack and into the power source.
AF-10 Boards
Important: Always use a UL approved power source. Check the power source’s
documentation for information specific to that power source.
To attach connectors & power to AF-10 boards:
1.
Insert the RJ-45 connector into the RJ-45 (CAT-5) receptacle (FIG. 5).
2.
Insert the HD-15 connector (see pinout in FIG. 6) into the HD-15 (RGBHV)
receptacle (FIG. 5).
3.
Plug the power cord into the AF-10 power receptacle and into the power
source.
TX & RX HD-15 Pinouts
HD-15 connectors on TX and RX modules and boards use the pinouts in FIG. 6.
FIG. 4
Attach RJ-45, HD-15, & power connectors
FIG. 5
Attach RJ-45 & HD-15 connectors
FIG. 6
HD-15 connector pinouts
10-79
RJ-45
HD-15
Power
RJ-45
HD-15
