Revise Date: 1/12/2016
n:\amtryke\manuals and instructions\models\hp-1000\hp1000 w-tilt steering assembly.doc
7 of 25
Leg Supports
1)
The leg supports are already attached. Due to constraints in packaging you will need to set them up.
2)
Leg support on the right side will need to be repositioned, pull the lower bar out of the main piece, pivot the
main piece to stick out on the right side, insert bar back into main piece & tighten.
3)
The left side will need to be pivoted to stick out like the right side & tightened down, do this after installing the
main steering.
Initial Appearance
Remove
Tube
Pivot
Downward
Insert Tube
Tighten
