heated tube lights, fans turn on, heated symbol in the upper left flashing. While rolling
on the screen displays the current temperature, has been heating time, moisture
content of the current sample.
6. End of the test, heated lamp automatic shut off, the buzzer alarm. Then the sample
is displayed on the moisture content, heating time, current temperature and the
parameter setting mode.
Note: Don't touch the sample plate, the temperature is too high now.
7 Press the "Reset" button, the instrument returns to weighing mode.
3.5 Parameters Setting
3.5.1 Heated parameter storage and recall
a. The instrument can store a total of 16 0-F group of heated parameters. Each group
can set the heating method, stop mode, time and time test parameters.
b. In weighing mode, press the "Settings" button to enter the parameter setting mode,
then store the address number (the number show the highest bit) is flashing. Press
"down" or "up" key to select the desired address number, the 0 is the factory
setting,1-F for the user store.
c. The memory address number 0 means factory settings, then click "ENTER" button
to exit the settings back to weighing mode. At this point heated mode is the
factory defaults.
d. When the memory address range for the 1-F any one number, press "ENTER" key,
and enter the parameter setting after the completion of a parameter (heated
mode, stop mode, time mode) setting. Press the "TARE" key, the address
number of the test parameters have been stored.
3.5.2 Heated mode and setting
（
）
a. Standard heated mode
：（
）
This mode is the factory setting, suitable for most samples. Heating
temperature can be set, the sample is heated to a temperature, and keep to
the test ends automatically.
b. Rapid heating mode: (
）
This mode is suitable for samples with higher moisture content. You can set
the heating temperature, heating the temperature will exceeds the set value,
the future will be reduced to the set temperature and hold until the test ends
automatically.
5
