AMSAN AM-TPL12CF, Manual

Page: 15 / 28

Two Post Car Lift AM-TPL12CF
15
chalk lines as shown in the picture in the last step.
•
Drill the anchor holes only for one post with a 3/4-inch drill bit into concrete
following the Anchoring guideline under the anchoring guideline section.
•
The second post will be anchored after the cables, hoses, and top crossbar are
installed.
•
Use a 4-feet leveler to check the level of each base plate. Place shims under the
base plate as needed.
•
Tighten all the anchor bolts and recheck for level.
•
Hammer down the anchor bolts all the way and then tighten them using a
torque wrench. Avoid using an impact wrench when tightening the anchor
bolts.
Step 3.
•
Now bolt the overhead beam to both posts. To avoid interference with the
cables when running the lift, be sure to bolt them together from the inside of
the beam.
Step 4.
•
Raise the sliding carriage on each column to the height of about 23” to 32” ,
then drop it to the safety latch stops and make sure it will not fall again.
•
See the top of the carriage where you will find two holes.
•
Run the cables as shown below.
•
Secure the second post by anchoring it down as described in previous steps.