AMSAN AM-TPL11CF, Manual

Page: 15 / 28

Two Post Car Lift AM-TPL11CF
15
•
Now stand up the other post opposite to the main power unit post inside the
chalk lines as shown in the picture in last step.
•
Drill the anchor holes only for one post with 3/4-inch drill bit into concrete
following Anchoring guideline under the anchoring guideline section.
•
The second post will be anchored after the cables, hoses and top cross bar are
installed.
•
Use 4-feet leveler to check the level of each base plate. Place shims under the
base plate as needed.
•
Tighten all the anchor bolts and recheck for level.
•
Hammer down the anchor bolts all the way and then tighten them using a
torque wrench. Avoid using impact wrench when tightening the anchor bolts.
Step 3.
•
Now bolt the overhead beam to both posts. To avoid interference with the
cables when running the lift, be sure to bolt them together from the inside of
the beam.