Single Post Lift AM-PSPL6
10
INSTALLATION
SPACE REQUIREMENTS
•
The area where the lift will be located should be free of overhead obstructions
such as heaters, building supports, electrical wires and so on. Also make there
is enough clearance around the lift for driving vehicles getting on or off the lift.
Please refer below for exact measurements.
•
There should be
>
about 1,000mm space around the vehicle lifted, and the net
height indoor is about 3600mm.
FOUNDATION REQUIREMENTS
•
Visually inspect the site where the lift is to be installed and check for cracked
or defective concrete
•
DO NOT
install or use this lift on expansion seams or on cracked or defective
concrete.
•
DO NOT install or use this lift on any asphalt surface or any surface other than
concrete.
•
Lift is designed for INDOOR INSTALLATION ONLY.
•
This lift must be installed on a solid level concrete floor with no more than 3-
degrees of slope.
•
Lift buyers are responsible for any special regional structural and/or seismic
anchoring requirements specified by any other agencies and/or codes such as
the Uniform Building Code (UBC) and/or International Building Code (IBC).
•
All models MUST be installed on 3000 PSI concrete
and have a minimum of 12”
thickness with steel or fiber mesh. New concrete must be adequately cured by
at least 30 days minimum.
TOOLS RECOMMENDED
⚫
Chalk Line
⚫
⚫
4 Foot Level
⚫
Set of Metric Wrenches/Sockets
⚫
⚫
Flat Screwdriver
⚫
Adjustable Wrench
⚫
⚫
Hex-Key / Allen Wrench Set
⚫
Locking Pliers
⚫
⚫
Needle Nose Pliers
⚫
Tape Measure
⚫
⚫
Rotary Hammer Drill
⚫
Step Ladder
⚫
⚫
3/4" Masonry Bit
⚫
Hammer
⚫
⚫
3 Gallons of Hydraulic Oil*
⚫
Crow Bar
⚫
Forklift
⚫
*Recommended Oil: ISO 32, ISO 46 Hydraulic Oil or Dexron III ATF
Summary of Contents for AM-PSPL6
