AMS TOUCHLESS, Operation And Service Manual

Page: 24 / 50

L0192A
18
CHANGING DIVIDERS
1. To remove, push rearward on the divider as far as it
will go, then lift it up and out of the tray.
2. Reverse the removal procedure to reinstall.
CHANGING HELICES
Each helix is snapped into an adapter which snaps into the vend
motor. To remove a helix from the motor, and while wearing
gloves, grasp the helix about one “turn” away from the motor, and
pull straight out sharply. Do not remove the helix adapter if the
helix is going to be reinstalled.
To install a helix, insert the end of the adapter into the motor, and
push the helix back towards the motor until the adapter snaps
into place. For helix install position see
HELIX HOME POSITION
on page 19.
HELIX ADAPTER
To remove, twist the adapter to free the mounting leg from the
locking tab. Reverse the removal procedure to reinstall.
HELIX EJECTOR
The ejector’s function is to cause the products to fall more
reliably and in the most favorable orientation. This will help retain
the next product in the helix coil, especially if they are difficult
products.
The helix ejector is pulled off and pressed onto the helix by hand.
The ejector is typically positioned half a coil, and often much less,
from the end of the helix. The “fin” shaped portion is angled
towards the front of the tray.
The best position and angle for the ejector is determined by test
vending products.
HELIX ALIGNMENT DEVICE
The helix alignment device is installed under the bottom left side
of the large helices to help keep them centered in their columns.
To remove, grasp the front of the helix alignment device with
pliers and pull or pry upward. Take care not to lose the plastic
mounting clips.
Reinstall by pressing the plastic mounting clips back into the
mounting holes. Note that the mounting flange goes toward the
helix.
MOTOR POSITIONS
Motor position can be changed sideways for different width
columns, and there are two mounting vertical positions on the
snack tray. The lower and upper positions are used for the small
and large diameter helices, respectively.
1. Remove the helix. Remove the harness terminals
(one small and one large).
2. Press down and rearward on the top mounting tab,
then pull the lower mounting legs out of the
mounting slots.
3. Reverse the removal procedure to reinstall.
4. After all motor changes have been made use the
Tray Setup option in Service Mode to configure the
motors.
5 TRAY ADJUSTMENT AND CONFIGURATION
Motor-
“0” = Leftmost Motor
“11” = Rightmost Motor
Wire Color
For Wide Tab
(+Terminal)
Wire Color
For Narrow Tab
(-Terminal)
0 Red Red/Black
1 Blue “
2 Gray “
3 Violet “
4 Brown “
5 Yellow “
6 Green “
7 Orange “
8 Black “
9 White “
Tray Motor Wire Colors
10 Gray/Red “
11 Gray/Blue “