AMS MFA-2001, User Manual, Page: 13 / 23

13
Switched output setup:
1. Press the T3 (OPT) key to activate the setup mode („LIMIT 1 ADJUST…).
2. Press the T1 ( ‡ ) or T2 ( ‚ ) keys to set the parameters to be monitored.
The following parameters can be selected:
Voltage U
„V…
Current I „A…
Frequency f „Hz…
Active power P,
received
„W…
Reactive power Q,
inductive
„var…
Power factor,
inductive /value/
„cos †…
Accumulated values „sum…
T3
‰ Accumulated active power „W sum…
Accumulated reactive power „var sum…
Power factor entire network „cos † sum…
Active energy „Wh…
Reactive energy „varh…
Operating time „h…
Additional options:
Impulse counter function „PUL… see below ŠSetup as impulse output•
Deactivation „AUS…
see below
ŠDeactivating the limit output•
After the selection has been made press the T3 (OPT) key to proceed to the next step.
3. Press the T1 ( ‡ ) or T2 ( ‚ ) keys to select the
phase
(channel) of the network parameter to be
monitored.
The following options are available:
for voltage
L1-N
L2-N
L3-N
L1-L2
L2-L3
L3-L1
for voltage
(3-phase monitoring)
L1-N, L2-N, L3-N
L1-L2, L2-L3, L3-L1
for current, frequency, power, power factor L1
L2
L3
for accumulated active power, accumulated reactive no selection (phase-independent)
power, power factor entire network, active energy,
reactive energy, operating time
After the selection has been made press the T3 (OPT) key to proceed to the next step.
4. Setting the response time . The response time is the time interval during which the limit value is
exceeded (resp. fallen below) in order to trigger an alarm.
Use the T1 ( ‡ ) or T2 ( ‚ ) keys to set the response time.
Adjustment range: 0....60 seconds
After the response time has been selected press the T3 (OPT) key to proceed to the next step.
The response time also applies if the switched output is reset because the programmed value has
been fallen below (resp. exceeded).