Amplicomms TCL 190, Operating Instructions Manual

Page: 7 / 15

Preparing the Equipment
22
4. Connect the equipment as illustrated in the diagram.
Only use the telephone connection line supplied
because the equipment may not function if another
telephone connection line is used.
Mains power outlet
Vibration pad
Telephone line socket
In order to connect the alarm clock to a telephone
connection for use as a signal amplifier, you may need
an appropriate adapter. You can obtain one at a
specialist shop.
Only use the power adapter plug supplied labelled with
output data 12 V
DC
, 670 mA.
Basic settings
In order to be able to use the TCL 190 alarm clock, you must first
carry out the following settings.
1. Set the time. Turn the rotary knob (15) until the clock shows
the correct time.
2. Set the time at which the alarm should go off. Turn the rotary
knob (14) until the red hand points to the time at which the
alarm should be triggered.
3. Use the sliding switch (7) to select the type of alarm (mode).
There are three settings available, from left to right vibration
only", acoustic signal only" or acoustic vibration".
4. Turn the rotary knob (4) to set the required volume. Firstly,
set the volume to quiet" (turn anticlockwise) and increase
the volume slowly.
Exposure to the alarm at full volume for a long period could
cause ear damage.
5. Turn the rotary knob (5) to set the required acoustic signal.
6. Turn the rotary knob (3) to set the required pitch for the
acoustic signal.
Use the rotary knobs for volume and pitch to select
settings whereby the alarm can serve its purpose with the
volume setting as low as possible. Depending on your
hearing, it is possible that you can detect higher or lower
pitch tones even at low volumes.
7. In order to activate the alarm to trigger at the set time, turn
the rotary knob (3) clockwise to On".
0844 800 6503 (Using an UK landline, at the time of going to print: calls cost 6p for connection charge and then 5p a minute. Mobile costs may vary.)