–5–
w w w. a m p l i g h t i n g . c o m
–5–
Install Luminaire in Railing, Deck Over-hang or Stair
Determine Luminaire Location
4
Determine the desired location for the luminaire.
Place the luminaire to the mounting surface and mark two points on the
mounting surface where the holes are on the ends of the luminaire. The
marks will be used for self-tapping screws or wall anchors.
Note: Wall anchors are required for certain installation conditions
(brick wall, concrete wall, etc.).
A wireway hole may be drilled through the decking fascia or other surface
adjacent to the mounting surface.
A. Hold the luminaire in the desired mounting location. Mark the
location where the wire exits the luminaire.
B. Drill a hole through surface (suggested 1/4” [6.5mm] hole).
C. Thread the wire through the drilled hole.
Self-tapping
Screw
Luminaire
Railing, Deck
over-hang or Stair
Mark
Install from Bottom
Install from Side
Self-tapping
Screw
Luminaire
Mark
Wireway
Hole
Railing, Deck
over-hang or Stair
Wireway Hole
