background image

[email protected] • 813.978.3900

INSTALLATION & MAINTENANCE GUIDE

AMP

®

 LED Hardscape Lights

AHS-67XX Series

This luminaire is intended for installation in accordance with local codes 

and the National Electric Code (NEC). Failure to adhere to these codes and         

instructions may result in serious injury, property damage and void the

warranty.

These instructions do not intend to cover all variations in installation,

operation maintenance or mounting situations.

     

1.  Make sure that the power is turned OFF before installing or servicing this 

luminaire.

2.  Warning: risk of electrical shock. Install all luminaires 10 feet (3.05M) or 

more from pool, spa or fountain.

3.  This luminaire is intended to be used only with a power supply       

(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.

4.  DO NOT INSTALL in walls where the capstones overhang the wall less than 

3/4” [19mm] or under stairs where the tread overhangs the riser less 

than 3/4” (19mm).

5.  Wiring connections must be made with wire connectors that are suitable 

for outdoor use.

6.  Position the low voltage wire and wire connector so that it is located 

within 6 inches (15.2 cm) from a building structure, a luminare, or          

fitting.

7.  The main low voltage cable is intended for shallow burial - less than 6 

inches (152 mm).

8.  If additional lengths of low voltage cable are required, please contact 

www.voltlighting.com or call 1-813-978-3700.

Package Contents

A. (1) Luminaire
B.  (2) Self-tapping Screw
C. (2) Wall Anchors

Important: Please Read Before Installation

!

Summary of Contents for AHS-67 Series









Reviews: