- 9 -
Fixed RFID Reader RF1B1AMUS User Manual V
1.00
4 Operation
Fixed RFID Reader is an integrated device with built-in antenna. It is user-friendly
without complicated operating procedures. The Reader will be able to start
operation immediately after installation and connecting to power. Its operating
procedures are listed below as Figure 4-1:
4.1 Start
Mode
It is called “Start Mode” while the Reader is connected with power. At this mode,
the red LED indictor is on. And the Reader will automatically check its functions: its
green and blue LED indictors flicker twice and the buzzer makes two short beep
sounds. Then, the Reader will step into Ready Mode. The red LED indictor will be
unceasingly lighting when the power is supplied.
4.2 Ready
Mode
It is called “Ready Mode” when no UHF Card in the detectable range of the IR. The
red LED indictor is on.
4.3 Read
Mode
During Ready Mode, when a UHF Card is coming closer to the Reader and
entering into the detecting range of IR, and green LED indictor is blinking, it means
the Reader is reading the information from the UHF Card and we called it “Read
Mode”. After confirming validity of the UHF Card, the blue LED indictor will flicker
once and the buzzer will make one long beep sound. The information of the Card
will be sent to the Control Box by weigand coding. It depends on the user’s
authority for the Control to open the Door. After previous actions, the Reader will
come back to Ready Mode.
Figure 4-1: Operating Procedures