AMIGO COMMERCIAL PRODUCTS
MAINTENANCE SCHEDULE
DAILY
• Charge when not in use. Extended charging will extend the life of the batteries.
• Check charge cord for damage and wear. Replace if damaged.
• Wipe seat, oval handle and control levers with a mild anti-bacterial surface cleaner.
• Check safety seat switch function – stand next to the Shopper, turn on and pull lever – the cart should not move.
In the event the cart moves, immediately take out of service and call for repair.
• SmartSensor - check sensor is free of tape, dirt, or debris. A damp cloth and mild soap can be used. Drive unit toward a
stationary object. Cart should slow down as it gets close and come to a full stop approximately 12 inches from the object.
MONTHLY
• Clean upholstery, plastic and metal with a mild surface cleaner.
• Check and tighten any exposed fasteners.
• Check anti-tip wheels. Replace damaged or missing anti-tip wheels.
• Check forward/reverse levers – be sure they move freely and cart remains in place when in neutral.
• Check basket signs and replace if missing or damaged.
• Drive unit through front entrance doors of store.
• Test cart's ability to travel through radio frequency security systems at front entrance of store.
For operating questions call the Amigo service department @ 1-800-248-9131 or 989-777-0910, 7:30 a.m. to 6:00 p.m. (EST)
Monday – Friday. Please reference serial number when calling. You may also contact us by fax at 1-800-334-7274 or email
[email protected]
Note:
Batteries should last 18-36 months if fully charged daily. Ensuring the AC cord is in good operating condition will
assist in extending battery life.
DO NOT EXPOSE THE AMIGO TO SPRAY-ON CLEANING SOLUTIONS AND EXCESSIVE MOISTURE SUCH
AS SPRAYING IT WITH A HOSE, OR LEAVING IT IN THE RAIN OR SNOW. EXCESSIVE MOISTURE AROUND
THE MICROPROCESSOR CONTROLLER (MPC) OR ELECTRICAL CONNECTIONS MAY CAUSE CONTAMINATION
OF ELECTRICAL CIRCUITRY, DAMAGE AND MALFUNCTION, AS WELL AS PERSONAL INJURY. THIS VARIETY OF
DAMAGE IS NOT COVERED UNDER THE WARRANTY.
Serial Number Locations:
• Back side of tiller underneath handle enclosure (Figure 6)
• Right side of lower seat post (toward outside top)
AMI serial number
Figure 6
1-800-248-9131
6
• SmartSensor - inspect sensor bracket and wiring for signs of abuse. Ensure the bracket is not bent and the
sensor is pointing straight forward. Ensure the wires and connections are secure and undamaged.
YEARLY
• Check static ground wire located under vehicle, replace if damaged or missing. Wire must be in contact with
floor when operating Shopper.
