Amiga M1438S, User Manual

Page: 4 / 32

INTRODUCTION
The Series 13 range of autoscanning monitor is suitable for use over a wide
range of horizontal and vertical scan rates; 15-40kHz horizontal rate and
45-1 OO Hz vertical rate. The displayed picture will also vary according to the
screen mode selected.
This monitor meets the requirements of the following directives and
standards:
•
EEC Low Voltage Directive
•
EEC Display Screen Directive
•
EMC Directive
•
SWEDAC Low Radiation
•
Safety of IT Equipment
73/23/EEC
90/270/EEC
(model dependent)
89/336/EEC
MPR-2 (model dependent)
EN60950
GUIDELINES FOR SAFE OPERATION
1
This product is not intended for use as a critical component in lite support
devices or any system in which failure could be expected to result in persona!
injury.
lt is most important that installation and operation are carried out in
accordance with the instructions given in this guide. ln the interests of
continued safe and reliable operation, observe the following guidelines:
ELECTRICAL SAFETY
•
Waming: This equipment must be earthed (grounded) to prevent
electrical shock hazard.
•
To disconnect the equipment from the power supply, the power lead
must be removed from the power outlet.
•
The equipment shall be installed near the power outlet, which shall be
readily accessible.
•
Do not operate this equipment if any cables are damaged.