Amico Go Lift Portable 450, Installation And Operation Instructions Manual

Page: 20 / 28

20 Amico Mobility Solutions Corporation
Electro-Magnetic Compliance Data for Amico GoLift Portable
Guidance and Manufacturer’s Declaration - Electromagnetic Emissions
The [EQUIPMENT or SYSTEM] is intended for use in the electromagnetic environment specified below.
The customer or the user of the [EQUIPMENT or SYSTEM] should assure that it is used in such an environment.
Emissions Test Compliance Electromagnetic environment – guidance
RF emissions
CISPR 11
Group 1
The [EQUIPMENT or SYSTEM] uses RF energy only for its internal
function. Therefore, its RF emissions are very low and are not likely to
cause any interference in nearby electronic equipment.
RF emissions
CISPR 11
Class A
The [EQUIPMENT or SYSTEM] is suitable for use in all establishments
other than domestic establishments and those directly connected to
the public low-voltage power supply network that supplies buildings
used for domestic purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fluctuations /
flicker emissions
IEC 61000-3-3
Complies
Use of this equipment adjacent to or stacked with other equipment should be avoided because it could result in
improper operation. If such use is necessary, this equipment and the other equipment should be observed to verify
that they are operating normally.
Use of accessories and cables other than those specified by Amico Mobility, could result in increased electromagnetic
emissions or decreased electromagnetic immunity of this equipment, and result in improper operation.
Portable RF communications equipment should be no closer than 30 cm to any part of the Amico GoLift Portable 450.
Otherwise, degradation of the performance of this equipment could result.