Amico Go Lift Portable 450, Installation And Operation Instructions Manual

Page: 12 / 28

12 Amico Mobility Solutions Corporation
The Amico GoLift Portable is switched on automatically when a button on the
hand control is pressed. The Amico GoLift Portable switches off automatically
after approximately three minutes without activation.
To replace the battery in the hand control, use a Phillips screwdriver to remove
the cover.
To pair & unpair the hand control to the portable lift:
1. Press and hold both the up and down button simultaneously on the hand control until the LED flashes Red and
Green (5 seconds), this will put the hand control in paring mode and unpair from the current lift. The hand control
will search for 10 seconds before going to sleep. If the lift is not found and paired during this time, wake the hand
control up again by pressing any button. The hand control will wake up still in pairing mode.
NOTE: The hand control holds the memory, if the lift is unpaired before the hand control, as soon as the hand control
is awake, it will override the lift and they will remain paired.
2. Press and hold both the buttons on the portable lift for 5 seconds, until the lift blinks Green. This indicates that the
lift is ready to be paired to a new hand control.
Charging the GoLift Portable
The charger plugs in into the port on the GoLift Portable.
The batteries should be charged on a regular basis. It is recommended that the lift be left on charge when not in
operation, and at the end of each day. This will maximize the life cycle of the batteries.
The GoLift Portable may remain connected to the charger indefinitely since the charger has a built-in regulator,
eliminating the danger of overcharging.
As a general rule, it is recommended that the lift be raised to a height that will not interfere with anything or
anyone while the lift is not in use.
!
Do not drain the batteries excessively. This will dramatically reduce the lifespan of the batteries.
If the slow beep sounds, be sure to recharge the battery as soon as possible.
!
If the GoLift Portable is not returned to the charger the batteries will be drained and damaged.
Operating the GoLift Portable
DOWN button
UP button