Amico Apollo MS-SC, Operation & Maintenance Manual

Page: 17 / 48

www.amico.com
17
Cleaning Procedures
Bleach Cleaning Instructions
If none of the approved cleaning products provide the disinfectant level required then use a solution of 5.25% Sodium
Hypochlorite diluted to 1 part bleach to 50 parts water (1000ppm), (volume to volume).
Bleach products are corrosive and degrading in nature and may cause damage to your product. If bleach is used,
measures must be taken to ensure the product is rinsed thoroughly with clean water and thoroughly dried. Failure to
rinse and dry the product will leave a corrosive residue on the surface possibly causing corrosion.
NOTE:
Failure to follow the above directions may void the product’s warranty.
• Do not expose the bed to excessive moisture
• Do not immerse the bed or its components in water
• Do not attempt to clean or degrease the steel shafts of the actuators
• Use only approved cleaning products. If bleach is being applied to the product, strictly adhere to the “Bleach
Cleaning Instructions“.
• For electrical components, please do not unplug the handset or actuators from the control box for cleaning
• Do not use a water temperature of more than 50°C or 122°F
NOTE: For mattresses, please refer to mattress cleaning instructions.
Before Cleaning
• Disconnect or unplug the power cord from the main supply
• Set the bed to BRAKE by pressing on the brake pedals
During Cleaning
• Do not use abrasive cleaning products
• Do not use oil-based products
• Do not use a steam cleaner, washing tunnel, high-pressure spray or hose
To Wash:
• Wipe with a sponge or soft cloth wetted with warm water containing soap or mild detergent
To Dry:
• Thoroughly wipe with a dry sponge or soft cloth
To Disinfect:
• Wash the surface with one of the approved cleaners or refer to the “Bleach Cleaning Instructions“ if bleach
needs to be used
• Wipe off residue with water using a soft cloth or sponge
• Thoroughly dry