21
MAINTENANCE AND CLEANING
I. Empty the water container
1. Pull out the water container with your both hands;
2. Pour the condensed water into the sink;
3. Replace the water container.
WARNING:
1. Empty the water after each use. If the container becomes full during the drying
cycle, programme will be stopped and
icon will flash. After emptying the con
-
tainer, you can restart the dryer by pressing [Start / Pause].
2. Do not drink the condensation water.
3. Do not use the dryer without water container in place.
II. Clean the top filter
1. Open the door.
2. Remove the top filter
3. Remove fibres and yarn collected on the filter mesh.
4. Replace the top filter
III. Clean the bottom filter
1. Open the filter cover.
2. Unscrew the two locking levers.
3. Pull out the filter body
4. Completely clean the filter mesh.
5. Replace the filter body!
6. Tighten both locking levers.
7. Close the filter cover.
NOTE
1. Fluff, threads, fibres collected on the filter block the air flow and thus extend the drying time and
increase the energy consumption;
2. Remove the plug from wall outlet before cleaning!
3. Do not operate the dryer without the filter!
4. Clean the filter after each use to prevent the accumulation of fluff, threads, fibres
inside the drum.
IV. Clean the heat exchanger
About every two months or when necessary, use a sponge or a soft brush to remove
fluff, threads and fibres from the heat exchanger.
Wear gloves when cleaning.
Note:
Fluff, threads and fibres can be removed easily when sprayed with water
Summary of Contents for WTP 14321 W
Page 24: ......