26
The warm up function keeps stable temperature of food on a heating zone. The selected
heating zone is set to low heating power. This function will help you enjoy warm food, ready
for serving at your convenience, that will not change taste or stick to the bottom of the pot.
This function can be used to melt butter, chocolate, etc.
To use this function correctly, please provide a pot with a flat bottom so that its temperature
can be accurately measured by the detector in the heating zone. The warm up function can
be activated on each zone. For microbiological reasons, it is not advisable to keep food warm
for too long. Consequently, when this function is used, the panel sensor will switch off after
two hours.
You can set 3 temperature levels on the heating zone: 42°C, 70°C and 94°C.
Activation of the warm up function should be performed as follows:
● press the warm up function sensor (12), which is signalled by switching on of the first
LED – this means choosing the heating level of 42°C.
● press the warm up function sensor (12) again, which is signalled by switching on of the
second LED – this means choosing the heating level of 70°C.
● press the warm up function sensor (12) for the third time, which is signalled by switching
on of both LEDs – this means choosing the heating level of 94°C.
● then, having selected one of the heating levels, press sensor (+) (2) for a specific heating
zone, which is signalled by the appearance on the display (4) of a symbol assigned to a
given level ( ) ( ) ( ).
The warm up function can be deactivated at any time by simultaneous pressing of sensor
(+) (2) and sensor (-) (3), or by reducing power to level (0) using sensor (-) (3).
OPERATION
Stop’n go function „II”
This function works like a standard pause. Using it, you can at any time suspend the hob
operation and return to previous settings.
To activate the stop’n go function at least
one heating zone has to be on.
Then press the sensor (11). On all indicators
of heating zones (4) symbol „II” comes on,
up and above the sensor (11) – the signal
LED comes on.
In order to deactivate the stop’n go function
you have to press the sensor again (11), the
signal LED begins to blink; then press any
sensor (2). Settings light up on the indicators
of heating zones (4) that were set before the
activation of the stop’n go function.
Warm up function
4
10
11
1
2
3
4
10
11
1
2
3
Summary of Contents for PB 5VI502FTB5 Series
