-
13
-
1
2
3
4
5
6
7
8
9
10
5
5
4
3
2
2
2
1
Heating power
level
Maximal time
in hours
Limited time of operation
For safety reasons, every single hotplate
is provided with an automatic device lim-
iting its time of operation. The maximal
times of operation are specified in the
near Table. A hotplate switches off au-
tomatically if the heating power has not
been changed during the specified time.
If you want to continue cooking, switch on
the hotplate again at the required level of
heating power.
Clock functions
(if applicable)
Your plate is provided with a clock which can be used as a control clock or timer.
The control clock can automatically switch off a hotplate after a set period of time.
The timer informs you with a beep that the set period of time has lapsed, the hotplate
does not switch off.
You may set both, the control clock and the timer, within the range of 1 to 99 min-
utes.
If the plate is provided with a control clock, all the hotplates can be controlled in the
following way:
1. Select the desired hotplate with the selection sensor (2). A digit is dis-
played.
2. Set the desired heating power with „+” (5) or „-”(4) sensors.
3. Within the next 5 seconds, again activate the selection sensor (2). The control
clock indictor is active. The heating power indicator is no longer lighted, the
hotplate indicator goes out and the control clock indicator is lighted on the
above or below indicator.
4. Set the time of operation for the hotplate with „+” (5) or „-”(4) sensors.
5. After activation of any hotplate sensor (2) or after 5 seconds, the heating
power indication is restored.
Flashing dot on the hotplate indicator shows that the control clock has been activated
for the hotplate.
After the set time, a short beep sound is repeatedly emitted. Digit “0” appears on the
hotplate indicator, there are two horizontal lines displayed above or below and the
hotplate is switched off.
To change the already made setting, repeat the setting process from points 1 to 5.
To deactivate the clock function, proceed with points (1) and (3) and then set the time
with “+”(5) or “-”(4) sensors to “00".
Summary of Contents for P*4VQ2 Series
Page 1: ...P 4VQ2 PB 4VQ2 Ceramic plate with touch con trol Operating Manual ...
Page 19: ... 19 ...
Page 20: ... 05 2007 1 IOAA 138 ...